Table of Contents
Advertisement
6.3 Operation with i-brush
1. Turn the hose of the standard equipment counterclockwise (Figure 20, pos 6).
2. Remove the hose from the can of the i-vac 9B®.
3. Insert the hose of the i-brush (Figure 20, pos 4) into the hose connector (Figure 20, pos 2).
4. Turn the hose clockwise to lock it into place.
5. Push the plug from the i-brush (Figure 20, pos 5) onto the connector on the i-vac 9B (Figure 20,
pos 1) and tighten the ring of the plug.
6. Press the ON/OFF switch (Figure 20, pos 7) to turn on the i-vac 9B.
7. Press the ON/OFF switch (Figure 20, pos 3) to turn on the i-brush.
8. Start vacuuming. The i-brush works best if no pressure is applied to the brush.
Figure 20
6.3.1 After operation with i-brush
1. Press the ON/OFF switch (Figure 20, pos 3) to turn off the i-brush.
2. Press the ON/OFF switch (Figure 20, pos 7) to turn off the i-vac 9B.
25
Advertisement
Table of Contents
