Advertisement
3.6
AIR VALVE ADJUSTMENT
It is possible to place your VOID air valve around the air can, and also position it toward or away from the
piggyback. This allows the shock to be fitted on a maximum of frames.
Caution :
Never place the valve in front of the piggyback, in the no-valve area, even if it is facing away from the
piggyback. The piggyback may hit the valve and seriously damage your shock.
To modify the direction of your valve, or rotate it around the air can follow the instructions below:
Place the head of the shock in a soft-jawed
vice (figure 1).
Caution :
Before tightening the vice, make sure the
jaws grip a flat surface and are not touching
the rebound knob.
Lightly tighten the vice jaws to prevent
damaging the shock.
Note your shock pressure, taking into
account the loss of pressure when
connecting your pump. Slowly deflate the
shock. The shock body will retract slightly.
Unscrew the air can while keeping the body
in its initial position (figure 2).
Caution :
The shock body must not be unscrewed.
The air can is unscrewed by hand
without additional tools.
1
3
2
4
4
Advertisement
