Advertisement
Remove the air can (figure 3)
Change the position of the valve sleeve if
needed and rotate it according on your
needs (figure 4).
Make sure you have aligned the air can (a)
sticker with the rebound knob (figure 5).
Replace the air can by screwing back by hand until the stickers align to ensure the proper torque (figure 6).
If the stickers do not align when the air can is hand tight, re-inflate and equalize the shock air chambers
(chapter 3.2) then finish tightening the air can.
Mount the shock on your bike; re-inflate it and equalize the shock air chambers (chapter 3.2).
Service
It is essential to clean your shock after each day of riding without waiting! Nothing is worse for the life of
your seals than dirt and dust.
The cleaning process is also extremely simple: wipe off the body and the seal with a clean, soft rag. You can
occasionally lubricate the exterior of the seal with fork oil.
Do not under any circumstances use degreaser, solvent, or any abrasive material.
On the same note, do not ever power wash the seals.
Recreational use
Racing use
Caution :
Oil changes and service should be performed at an official BOS service center. These are the only
locations able to identify and resolve damaged or worn parts on your product, especially in the case
of extreme shocks or premature wear on structural elements such as body, mounting kits, and shaft.
5
Cleaning
After each ride
After each ride
6
Oil service
Once a year
Once a year
3.
Maintenance11
Full service
Every two years
Once a year
B
!
A
Advertisement
