Table of Contents
Advertisement
4
OPS INSTALLATION
4.1
Make sure that the machine is parked on
flat, level ground, with the cutting units
down in the cutting position with the
brakes on, ignition off & the key removed
from the ignition. Disconnect Battery.
4.2
Disconnect Seat Switch Harness from the
seat, and remove seat from the machine.
4.3
Review Seat Platform to see if slots have
to be added to the platform. see drawing
opposite. Mark out and add slots if
required.
Important : If Old Milsco Seat fitted
(indentified by plastic back to seat,
instead of metal structure). The Seat will
have to be re-located on the seat plate, to
allow seat belt bracket (4133935) to fit as
required in step 4.5. 2off 9mm dia holes
may have to be added if not currently on
seat plate.
4.4
Remove existing seat platform Rubber
Stops (Part Number 523224). And Re-
assemble with New Seat Plate stops fitted
(Part Number 4134558). Ensure Seat stop
plates are assembled as detailed, and line
up with slots in seat platform. Readjust
lock nut on Rubber Stops to ensure seat
platform seats level.
JACOBSEN G-PLEX III
OPS FITTING INSTRUCTIONS
GB-5
Advertisement
Table of Contents
