Fish Arches - Eagle FishEasy ST Installation And Operation Instructions Manual

hull. Place the transducer into the epoxy, twisting and turning it to force
any air bubbles out from under the transducer face. The face of the
transducer should be parallel with the hull, with a minimum amount of
epoxy between the hull and transducer. After the epoxy dries, route the
cable to the sonar unit.

Fish Arches

If you do not get good fish arches on your display, it could be the
transducer is not parallel with the ground when the boat is at rest in the
water, or at slow trolling speeds. If the arch slopes up, but not back
down, then the front of the transducer is too high and needs to be
lowered. If only the back half the the arch is printed, then the nose of the
transducer is angled too far down and needs to be raised.
TRANSDUCER AIMED TOO FAR TRANSDUCER AIMED TOO FAR TRANSDUCER AIMED TOO FAR TRANSDUCER AIMED TOO FAR TRANSDUCER AIMED TOO FAR
B A C K B A C K B A C K
B A C K B A C K
PROPER TRANSDUCER ANGLE PROPER TRANSDUCER ANGLE PROPER TRANSDUCER ANGLE
PROPER TRANSDUCER ANGLE PROPER TRANSDUCER ANGLE
10
TRANSDUCER AIMED TOO TRANSDUCER AIMED TOO TRANSDUCER AIMED TOO TRANSDUCER AIMED TOO TRANSDUCER AIMED TOO
FAR FORWARD FAR FORWARD FAR FORWARD
FAR FORWARD FAR FORWARD