Intended Use; Tester Information - Uniks M80 User Manual

USER MANUAL M80
The tester may be used only within the specified measurement ranges and in low-voltage
installations up to 1000 Vac/1500Vdc.
The tester may be used only in the measuring circuit category it has been designed for.
Before and after use, always check that the tester is in perfect working order (e.g. on a
known voltage source).
The tester must no longer be used if one or more functions fail or if no functionality is
indicated.
It is not permitted to use the tester during rain or precipitation.
A perfect display is guaranteed only within a temperature range of -5°C to +40°C at relative
air humidity less than 85%.
If the safety of the user cannot be guaranteed, the tester must be switched off and secured
against unintentional use.
Safety is no longer guaranteed e.g. in the following cases:
•
obvious damage
•
broken housing, cracks in housing
•
if the tester can no longer perform the required measurements/ tests
•
stored for too long in unfavorable conditions
•
damaged during transport
•
leaking batteries
The tester complies with all EMC regulations. Nevertheless it can happen in rare cases that
electric devices are disturbed by the electrical field of the tester or the tester is disturbed by
electrical devices.
Never use the tester in explosive environment
Tester must be operated by trained users only
Operational safety is no longer guaranteed if the tester is modified or altered.
The tester may be opened by an authorized service technician only.
If the indication "voltage present" appears although the checked part is considered as
disconnected, it is recommended to verify additional measures if the measured voltage is
an interference voltage or not.

4. Intended Use

The tester may be used only under the conditions and for the purposes for which it was designed.
Therefore, observe in particular the safety instructions, the technical data including environmental
conditions.

5. Tester Information

1. Test Probe, L1
2. Test Tip, L2
3. Torch Light
4. Display
5. Torch Light Button / Activation R-measurement
6. Trip TEST RCD Pushbuttons
7. Main body
8. Battery door
1
6
12
2
3
4
5
7
8