Table of Contents
Advertisement
Input the desired settings, then turn on the simulator by highlighting
the
S
IMULATOR
back to the main page display. A message will appear periodically,
warning you the simulator is on. To turn the simulator off, repeat the
steps above or turn off the unit.
To use the
S
TEER WITH
GPS simulator menu and press
page display. Press
simulation.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set
to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
4. Press
to turn off the steering and speed boxes. The unit will now
EXIT
automatically steer along the trail or route. When you arrive at your
destination, cancel navigation as you normally do.
Tip:
You can pick any spot on the map to begin your simulation by using
the Initialize GPS command.
box and pressing
O
N
A
RROWS
to turn off the option without affecting the
EXIT
to clear the alarm.) When navigation starts,
EXIT
. Press
ENT
option, highlight
. You will be directed to the map
ENT
S
A
TEER WITH
RROWS
139
repeatedly to get
EXIT
S
A
TEER WITH
RROWS
command and press
on the
S
P
TARTING
O-
ENT,
Hide quick links:
Advertisement
Table of Contents
