Eagle CUDA 250 S/Map Installation And Operation Instructions Manual page 143

NOTE:
When the position format is changed, it affects the way all positions
are shown on all screens. This includes waypoints.
To change the coordinate system, press
lighted at the top of the Coordinate System menu. Use ↑ ↓ arrow keys
to select the desired format and press
To setup Loran TD:
1. From the Coordinate System menu, press ↓ to
press .
ENT
NOTE:
If the Loran TD conversion is chosen, you must enter the local Lo-
ran chain identification for the master and slaves.
2. To access the Loran Chain, Secondary 1 or Secondary 2 menus,
highlight the category and press
desired setting and press
Setup Loran TD highlighted on Coordinate System menu (left). Con-
Press
ENT.
figure Loran TD menu (right).
135
while
ENT
.
ENT
Use the
ENT.
to close the menu
EXIT
C S
OORD YSTEM
S L
ETUP ORAN
↑ ↓
keys to choose the
.
is high-
and
TD