Mounting Rackmount Kit (Option 1Cm); Mounting Rackmount/Handle Kit (Option 1Cp) - Agilent Technologies E5091A User Manual

Mounting rackmount kit (Option 1CM)

The rackmount kit is a kit that contains 2 flanges (side plates for securing) to mount the
E5091A into the standard rack (width: 482.6 mm) of the EIA standard. Follow these steps
to mount it, referring to the Figure 1-6.
Step 1. Remove the trim strips (1) stuck to both the sides of the front panel (stuck to the frame).
Step 2. Mount the flanges for rackmount (2) to both the sides of the front panel of the E5091A
with the attached screws.
Step 3. Remove the four legs on the bottom of the E5091A (pull up the part with the (TAB
indication and slide it to the arrow direction).
Step 4. Mount the E5091A into the rack.

Mounting rackmount/handle kit (Option 1CP)

The rackmount/handle kit is a kit that contains both the flanges for rackmount and the front
handles for the E5091A. Follow these steps to mount it, referring to the Figure 1-6.
Step 1. Remove the trim strips (1) stuck to both the sides of the front panel (stuck to the frame).
Step 2. Mount the front handles (3) and the flanges for rackmount (5) to both the sides of the front
panel of the E5091A with the attached screws.
Step 3. Remove the 4 legs on the bottom of the E5091A (pull up the part with the (TAB indication
and slide it to the arrow direction).
Step 4. Mount the E5091A into the rack.
1
Mounting front handles/flanges for rackmount
Installation
19