To Remove The Pipe Port Cover; Connecting The Drain Piping; General Guidelines; To Connect The Piping On Right Side, Right-Back, Or Right-Bottom - Daikin FTXP50M2V1B Installer's Reference Manual

6.3.3 To remove the pipe port cover

6.4 Connecting the drain piping

In this chapter
FTXP-M + FTXF-D + FTXF-A + ATXF-A
Daikin room air conditioner
4P513661-12L – 2021.07
3 Insert a wall cover into the wall pipe.
a b
c
a Wall embedded pipe
b Putty
c Wall hole cover
4 After completing wiring, refrigerant piping and drain piping, do NOT forget to
seal the gap with putty.
INFORMATION
To connect the piping on right-side, right-bottom, left-side or left-bottom, the pipe
port cover MUST be removed.
1 Cut off the pipe port cover from inside the front grille using a coping saw.
2 Remove any burrs along the cut section using a half round needle file.
NOTICE
Do NOT use nippers to remove the pipe port cover, as this would damage the front
grille.
6.4.1

General guidelines..................................................................................................................................................

6.4.2

To connect the piping on right side, right-back, or right-bottom.........................................................................

6.4.3

To connect the piping on left side, left-back, or left-bottom................................................................................

6.4.4

To check for water leaks ........................................................................................................................................

6 Unit installation
|
26
27
27
28
Installer reference guide
25