Additional Information - Prestige medical Anima User Manual

12
Section 8:

Additional Information

Operator:
The person assigned to use the autoclave.
Responsible Person:
The person who is responsible for the management of the
equipment, load assignment, care and maintenance. This
person is also responsible for ensuring that all applicable
Health & Safety Regulations are applied including those
relating to the pressure vessel.
This person must verify that only suitably qualified persons
undertake repair and maintenance work other than that
described under "Routine Care and Maintenance" within
this handbook.
Qualified Person:
A person who is qualified by training or experience to a
recognised level in respect of the work to be undertaken.
Service:
Calibration and maintenance as required.
Manual Handling:
Due to the weight of the unit two people are required when
unpacking or moving the product.
UNPACKING.
When lifting the unit out of the box ensure there is one
person on either side of the unit. Lift out of the box and
place on the work surface.
POSITIONING.
Start lifting by holding the unit below the front bezel (large
plastic moulding). As clearance is gained, lift at the other
corners. Place in position, and release in the reverse
order to lifting. NOTE Always drain the water tank before
moving. Before moving always allow 30 minutes after use
for the unit to cool down.
Cleaning Materials:
Mild washing up liquid. Non-abrasive cream cleaner.
Disinfectant diluted in water. Autoclave Cleaning Kit
289138.
Product decontamination.
Should the unit require repair, it must be decontaminated
in accordance with a recognised procedure prior to return
or on-site repair. A statement of equipment contamination
status must be available with the product.
Details of a suitable procedure are available on request
from Prestige Medical Ltd.
304278B
Approvals:
Approvals are all model specific. However, the following
standards apply in whole or part:
• Medical Devices Directive (MDD 93/42/EEC)
• Electro Magnetic Compatibility Directive.
• European Sterilizer Standard (EN13060)
• Pressure vessel to ASME Section 8.
• BS EN 61010 Parts 1 and 2
Spares:
Only those spare parts supplied or specified by Prestige
Medical should be used in the maintenance of the
autoclave. Use of unauthorised parts will invalidate any
warranty and may adversely affect the performance or
safety of the unit.
Accessories / Consumables
Printer roll (Part No.279505): Ten replacement rolls.
Furniture:
Tray / Rack lifter (Part No.279007):
Optional Furniture
5 Clip tray set (Part No. 309093)
Door tool (Part No.309068):
Door plate thumb screw (Part No.309070)
Sealing gasket x 4 (Part No 279571 )
Gasket for a 250mm. diameter chamber.
"O" Ring door (Part No.279100):
Waste Water Container (Part No.279503
Container for single use water.
Test Pack (Part No.309031)
Prestige Medical Ltd approved TST Helix available from:
Albert Browne Ltd.
Leicester
LE5 1QZ
UK
Order Code 3781.
Autoclave cleaner (Part No.289138):
For cleaning the autoclave to ensure continued operation.
Air filter (Part No.273096A):
Replacement air filter.