7. SERIES 2 PROJECTOR SETUP
7.1.1. Barco Touch Panel Setup
The Barco Projector touch panel can be used to control the SX-4000. Use the following steps to
set up control of the SX-4000 from the Barco touch panel.
1. On the Barco touch panel, select [Control] [Server]. The new window
[Connection Properties] will appear as shown in Figure 21.
2. Enter the SOM IP address of the SX-4000 into the [Host Name] field. The remaining
fields should be filled in as follows (please refer to Figure 22):
Display or port: 5900
Check the [Use as port] checkbox
Password: gdcvnc
3. Click the [Connect now] button, the SMS user interface will be shown on the Barco
touch panel.
Installation Manual for SX-4000 Standalone Integrated Media Block™
with Enterprise Storage/Enterprise Storage Plus
Figure 21 Barco touch panel settings [Connection Properties].
Figure 22 Barco touch panel settings [VNC Viewer Connection].
- 33 -
November 12, 2016