Connecting The Monitor; Connecting The Spot Monitor; Connecting The Rgb Monitor - Siemens SISTORE AX4 User Manual

Hide thumbs Also See for SISTORE AX4:

Table of Contents

Installation

2.7

Connecting the Monitor

2.7.1

2.7.2

Siemens Building Technologies

Fire & Security Products

NOTE:

The DVR may not support some LCD monitors or some monitors don' t support Multi Sync.

NOTE:

You cannot use spot monitor output and VGA output at the same time.

NOTE:

Set the CVBS (SVHS) or VGA selector switch before turning on the DVR. You cannot change the

setting while the unit is running.

Fig. 7

Video Out connectors.

Connect the SPOT monitor to either the Video Out or SVHS Out connector.

NOTE:

For SPOT monitor Output, set the CVBS (SVHS)/VGA selector switch to the CVBS (SVHS).

NOTE:

If your monitor has an SVHS input, use it because it will give you better quality video display.

NOTE:

The Video Out (BNC) and the SVHS Out connectors may be connected to individual monitors for

simultaneous operation.

Fig. 8

VGA connector.

A VGA port is provided for RGB monitor output. Connect the RGB monitor to the

VGA connector if required. Connect an RGB cable with a DB-15 (male) connector,

which is usually less than 10 feet, to the DVR connector.

NOTE:

For RGB monitor output, set the CVBS (SVHS)/VGA selector switch to the VGA.

SISTORE AX4_EN.doc

09.2004

Table of Contents