Hitachi E990 Installation Manual page 3

Installing your storage system
Hitachi Virtual Storage Platform E990 storage systems are designed for self-installation, so
you can install and set up your storage system for the first time without assistance from a
Hitachi Vantara representative.
Make sure your data center meets all site preparation requirements before you install the
storage system. If you are not using a Hitachi Universal V2 or Universal V2B rack, make sure
the electrical specifications of your rack meet the power requirements of the storage system.
Step 1: Unpack the storage system
Procedure
1. Inspect all materials for signs of damage. If you see damage, discontinue the installation
and contact your Hitachi Vantara representative.
2. Loosen the band around the cartons and open all boxes. Remove all packing materials,
envelopes, and boxes from the cartons.
3. Retain all packing materials and cartons in case you need to transport or ship the
storage system in the future.
4. Check the items you received against the packing list. If any items are missing or
damaged, discontinue the installation and contact your Hitachi Vantara representative.
5. Check the labels of each controller and drive box and verify the location of each
component on the rack layout diagram.
6. Place the keys for the front bezel in a safe place. You will need them to attach the bezel
to the front of the controllers.
Step 2: Verify component location in the rack
The controller and drive boxes for the VSP E990 are shipped fully configured and must be
installed in the rack at the specific location designated by the rack layout.
Each pre-configured component is shipped with two identification labels: one attached to the
shipping box, the other attached to the component itself. The labels include a unit number
that corresponds to a location on the rack layout.
An example rack layout is shown in the following figure:
Installing your storage system
Hitachi Virtual Storage Platform E990 Installation Guide 3