Hitachi Travelstar 5K160 Install Manual

Hitachi Global Storage Technologies

Quick Installation Guide

Hitachi Travelstar
2.5-inch ATA/IDE & SATA Hard Disk Drive
Models:
HTS(E)541616J9AT00
HTS(E)541612J9AT00
HTS(E)541680J9AT00
HTS(E)541660J9AT00
HTS(E)541640J9AT00
Handling precautions
__________________________________________
• Wear a grounded wrist strap while handling the
drive to prevent damage from Electrostatic
Discharge (ESD).
• Set the drive down gently to prevent damage
from impact or vibration.
• Do not open the ESD bag containing the drive
until needed.
• Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
• Do not press on the top or bottom of the drive.
• Do not cover the drive's breather hole.
Quick installation
__________________________________________
Installation of this Hitachi Travelstar drive in
some notebooks may require use of unique
hardware (such as mounting trays, connecting
cable, insulating material). If you are uncertain if
hardware is needed, consult your notebook
manufacturer as this operation may require a
qualified technician.
Back up all data before proceeding with
installation.
Page 1
™
5K160
(E)
HTS(E)541616J9SA00
HTS(E)541612J9SA00
HTS(E)541680J9SA00
HTS(E)541660J9SA00
HTS(E)541640J9SA00
1. Set the jumpers (ATA/IDE only)
• Master drive. No jumper is required if the drive
is the only drive in a system or the Master
drive in a two-drive system.
• Slave drive. If this is the Slave drive in a
system, place a jumper in setting A2. (See
the A2 setting in the illustration.)
• Cable Select. Setting A3 in the illustration.
Consult the system manual to see if your
computer supports Cable Select.
Jumper settings (ATA/IDE only)
2. Attach the drive
For assistance on the physical installation of
the drive, consult your system manual.
3. Configure the computer
1. Turn on the computer.
2. Enter Setup.
Travelstar (E)5K160