Hitachi E990 Installation Manual page 19

7. Click Finish, and then click OK, Apply, and Close.
Next steps
Run the Initial Setup wizard.
Running the Initial Setup wizard
The Initial Setup wizard allows you to configure system information, date and time settings,
and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the bottom of
each window allow you to apply or skip the settings on that window. If you skip settings, you
can complete them later by running the Initial Setup wizard again. To display details about
the settings in the windows, click the question mark icon in the bottom right.
Before you begin
Log in to Storage Advisor Embedded, and then open the maintenance utility by clicking the
gear icon at the top-right corner and selecting User Administration.
Procedure
1. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
Tip: Initial Setup Wizard is near the bottom of the navigation tree. If you do
not see this selection, scroll down the tree.
Installing your storage system
Hitachi Virtual Storage Platform E990 Installation Guide
Running the Initial Setup wizard
19