Table of Contents
Advertisement
Chapter 3 Disassembling and Reassembling
Pay attention to the following matters in maintenance work
Caution:
(1) Do not disassemble, reassemble, nor adjust the printer without reasons, if it works normally.
Do not undo carelessly screws for fixing components in particular.
(2) Upon completion of inspections, be sure to check the printer for an anomaly before turning power on.
(3) Never print without setting paper to the printer.
(4) Confirm that paper has been set normally.
(5) Be careful not to leave parts, screws, or others used for maintenance work in the printer.
(6) In handling the print head, do not use gloves that are easy to generate static electricity.
(7) In disassembling and reassembling work, check cables and cords for damage or defects, and do not lay
them facibily
3-1 Tool List
* (+) Screwdriver (No. 0).
* Pincette.
* Mini-radio-plier.
* Oil brush.
* Mini-nipper.
3-2 Procedure for Disassembling
For disassembling the printer, remove parts from the frame assembly according to 3-3 "Procedure for
Reassembling", but in the opposite order.
3-3 Procedure for Reassembling
Parts names used in the explanation are based on those in shown in "Parts List" in Chapter 5. These part names are
commonly used over this service manual.
10
MLT-288 Service Manual
Advertisement
Table of Contents
