The Installation Space (Per Unit); Grounding The Unit - Monogram ZIK303NPPII Installation Instructions Manual

Design Guide (One, Two, or Three Units)

THE INSTALLATION SPACE (Per Unit)

Water and Electrical Locations
Locate electrical and water supply connections in the areas shown on the Cabinet Dimensions section page.
WARNING
Connect to potable water supply only.
PREPARING INSTALL WATER LINE
• A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120
p.s.i. (275-827 kPa).
connection location.
• Tubing should be long enough to extend to the front of the enclosure.
• Water line can enter an opening through the floor or back wall.
• Install a shut-off valve between the icemaker water valve and cold water supply in the home.
NOTE:
• It is recommended that the water shut-off valve be placed in a location that is easily accessible. We do not advise
placing it behind the unit because of access difficulties. If it is necessary to install the valve behind the unit, it must
be located in the area shown on Design Guide.
• Saddle type shut-off valves are included in many water supply kits, but are not recommended for this application.
• The only GEA-approved plastic tubing is supplied in the SmartConnect
other plastic water supply line because the line is under pressure at all times. Other types of plastic may crack or
rupture with age and cause water damage to your home. See water line kits on Assessories Page.
• Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use
is not permitted in Massachusetts. Consult with your licensed plumber.
Electrical Specifications
• A 115-volt, 60-Hz., 15- or 20-amp power supply is required. An individual properly grounded branch circuit or circuit
breaker is recommended.
• Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on
rear wall as shown in the Cabinet Dimensions section.
NOTE: GFI (ground fault interrupter) is not recommended.

GROUNDING THE UNIT

WARNING
Hazard.
Failure to follow these instructions can
result in death, fire, or electrical shock.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
three-prong (grounding) wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
31-1000169 Rev. 4
Electrical Shock
™
plastic tubing between the house cold water line and the water
™ Refrigerator Tubing kits. Do not use any
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
UNIT TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
7