Monogram ZIK303NPPII Installation Instructions Manual page 23

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 2 INSTALL HEATER UNIFICATION KIT(S) TO UNIT 2 (cont.)
Place the heater harness into the hole using the strain
relief from the kit and push wiring connector towards
the front of the unit.
Strain
Relief
Reattach back cover.
Attach joining bracket to unit 2 using screws from
the kit.
Remove tape and band from unit 1.
Attach joining bracket to unit 1 using screws from
Heater Unification Kit.
31-1000169 Rev. 4
Installation Instructions
Back Cover
Joining
Bracket
23
Attach trim cover holder clips to the left side of unit 1,
4mm from the front edge. Clip 1 should line up with
the hole at the upper left corner.
up just below the top door. Clips 2 and 3 should be
evenly spaced between the 2. Notice these clips are
front corner, 4mm from the front edge. Clip 5 should
be spaced evenly between clips 4 and 6. Clip 7 should
be attached to the upper right corner, 4mm from the
back edge. Clip 8 should be attached to the back edge
of the refrigerator lined up with the hole in the joining
bracket.
Spacer Clips
1,4-8
Clip 4 should line
Spacer Clips
2, 3
1
7
2
3
4
5
8
6