Step 2 Install Heater Unification Kit(S) To Unit 2 - Monogram ZIK303NPPII Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)

STEP 2 INSTALL HEATER UNIFICATION KIT(S) TO UNIT 2

WARNING
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the appliance with the anti-tip system.
Do not remove the top door band or front door/drawer
tape.
Remove any remaining stickers and tape from the left
side of the second unit to be able to properly install the
Heater Unification Kit. DO NOT remove the warning label.
Wipe the surface with a dry, clean cloth.
Open the Heater Unification Kit(s) and make sure
all parts are included. You will need one Heater
Unification Kit for each unit other than the first.
1. Trim cover (ABS) : 1 piece
2. Trim cover holder clips with double-sided adhesive
tape : 8 pieces (2 are different)
3. Back side bracket (metal corner piece) : 2 pieces
4. Screw M6x45 : 3 pieces
5. Nut M6-8 : 3 pieces
6. Washer 6-INOX : 6 pieces
7. Screw 4.8x13 (for bracket attachment) : 4 pieces
8. Strain relief (for heater wiring) : 1 piece
9. Screw M4x18 : 2 pieces
10. Washer A4-NR : 4 pieces
11. Nut M4x3-NR : 2 pieces
12. Heater : 1 piece
13. Transformer with Heater jumper harness - 1 piece
1
2
3
12
Installation Instructions
Tip Over Hazard.
13
6
7
5
11
8
10
9 4
Remove paper backing from heater and carefully apply
heater to left side of unit 2. Apply heater 3/8" (1 cm)
from the front edge and 4" (10 cm) from the top edge.
NOTE: Heater is always applied on the left side (when
facing the front) of the unit. Heater may cover the lower
portion of the warning label.
3/8"
(1 cm)
4" (10 cm)
Tape
Secure the heater harness with tape and remove the
back cover screws.
22
Screws
Back
Cover
31-1000169 Rev. 4