Installation Instructions For Single Unit - Monogram ZIK303NPPII Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR SINGLE UNIT

TOOLS REQUIRED
• Utility knife
• Stepladder
• Bucket
• Level
• Appliance hand truck
• Tubing cutter
• #2 Phillips screwdriver
• Drill and bit set
• Safety glasses
• Pliers
• Torx T-20, T-30 wrench
HARDWARE SUPPLIED
• Anti-tip bracket & screws
• Panel installation kit
• Door panel templates- Pub # 31-1000149, 31-1000150,
31-1000151, 31-1000152
• Water filter - Part # XWFE
• Drywall Anchors and screws
UNIT LOCATION
Do not install the unit where the temperature will go
below 60°F (16°C). It will not run often enough to
maintain proper temperatures.
Do not install the unit where temperatures will go above
100°F (37°C). It will not perform properly.
Installation Instructions
MATERIALS REQUIRED
Refrigerator Tubing kits
• Water shut-off valve
• Custom panels for refrigerator door, freezer drawer and
Convertible drawer
• Velcro w/adhesive if using custom toekick.
FLOORING
For proper installation, this unit must be placed on a level
surface of hard material that is at the same height as the
rest of the flooring. This surface should be strong enough
to support a fully loaded unit, or approximately 1,200 lbs.
NOTE: Protect the finish of the flooring. Cut a large sec-
tion of the cardboard carton and place under the unit
where you are working.
Do not install the unit in a location exposed to water
(rain, etc.) or direct sunlight.
Do not install the unit on a floor not strong enough to
support it fully loaded.
12 31-1000169 Rev. 4