Step 11 Slide Units Into Enclosures; Step 12 Install Hinge Guard; Step 13 Connect Heater - Monogram ZIK303NPPII Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 11 SLIDE UNITS INTO
ENCLOSURES
Roll the units into the enclosure, being careful not to
pinch the water lines or power cords.
the front edge of the anti-tip bracket over the unit.
If space allows, you may also bend the front edge of
the bracket upward slightly, allowing it to clear the
back of the unit.
Remove top-center trim cover from units.
Secure the unit to the Anti-tip bracket using both
machine screws & washers to engage the threaded
inserts in the anti-tip bracket.
Hand start the screws until unit is in desired location
within the install space.
Finalize unit install by tightening the screws fully.
Reinstall trim covers.
Installation Instructions
28

STEP 12 INSTALL HINGE GUARD

Locate panel attachment set in the bottom drawer.
upper and lower hinge side of the door.
Hinge Guard

STEP 13 CONNECT HEATER

from the bottom of the units.
units.
Vent
Screws
(behind
toekick)
Screw
using jumper included with Heater Unification Kit.
Heater
Vent
Screw
Toekick
31-1000169 Rev. 4