Step 1 Remove Packaging - Monogram ZIK303NPPII Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR SINGLE UNIT

STEP 1 REMOVE PACKAGING

WARNING
This appliance is top heavy. Use extreme caution
with moving to prevent tipping over which could
result in death or serious injury.
Cut bands and tape on the top and bottom
of packaging with a utility knife.
Unfold the cardboard seams and remove the top
of the packaging.
Slide the remainder of the box off of the appliance. You
can use a box cutter to cut the remaining cardboard
being VERY CAREFUL not to scratch
the appliance.
Remove the EPS supports from around the unit.
DO NOT remove the door band or lower EPS banded
parts until unit is ready to go into enclosure.
Remove anti-tip bracket and foam blanket from top of
unit and set aside for installation later.
Keep front door band and door/drawer tape on unit
until product is installed to anti-tip bracket.
Remove trim pieces taped to front of product and set
aside for installation later.
Remove all packing tape except for warning labels and
tape with orange warning labels.
Pull back, but DO NOT REMOVE, door/drawer tape.
Open middle drawer and remove Owner's Manual
packet which includes unit installation instructions.
Close middle drawer and re-apply tape to keep the
door and drawers closed until product is installed to
anti-tip bracket.
Cut EPS skid at the sides near the front from the back
of the unit.
Push unit forward & remove rear portion of the EPS
skid.
Carefully lower rear onto the floor.
Lean unit back slightly & remove front portion of the
EPS skid.
Discard all unused packaging materials appropriately.
The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
Leave any protective film on the unit until installation is
complete.
31-1000169 Rev. 4
Installation Instructions
Tip Over Hazard.
13