Nstallation; Installation - GE 29880 User Manual

I

NSTALLATION

I
NSTALLING AND
Your Caller ID telephone with answering system uses one 9-volt alkaline
battery (not included) for backup power. In the event of a power outage,
you are still be able to use this phone to make and receive calls and
answering system messages and Caller ID information stored in memory
is retained.
CAUTION: Always disconnect phone cords from the wall outlets before
battery installation or replacement.
To install the battery:
1. Carefully turn over the phone. Remove the battery compartment door
on the bottom of the unit by loosening the screw with a Phillips
screwdriver. Lift the door.
2. Connect a fresh or replace the old 9-volt alkaline battery (not included). The
large and small contacts on the battery clip and the battery will interlock.
Once connected, place the battery inside the battery compartment.
3. Replace the battery compartment door and tighten the screw.
R
EPLACING THE
Battery
compartment
B
ATTERY
Battery
Battery clip
7