How To Install Your Canopy Housing (Close-To-Ceiling) - Fanimation EDGEWOOD FP9052 Series Manual

How to Install Your Canopy Housing (Close-to-Ceiling)

1. Lift the fan off the hanger bracket hook and mount
your fan by sliding the ceiling canopy over the
mounting bracket with the two loosened screws going
into the "L" slots in the canopy. Be sure all wiring is
tucked into the ceiling canopy and is not pinched.
Once the canopy is flush with your ceiling, turn
clockwise to seat the screws into the keyed portion of
the slot. Tighten the screws. (Figure 1)
2. Install the remaining two screws removed in step 1
of page 10 (How to Hang Your Ceiling Fan) to secure
the ceiling canopy to the hanger bracket. (Figure 2)
3. Push the canopy trim ring up to conceal the screws,
such that the mounting tabs seat into the dimpled
grooves in the ceiling canopy midway between the
screws. (Figure 3)
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
Screw
Slot
Mounting
Tab (4)
13
Screw
Hanger Bracket
Slot
Figure 1
Figure 2
Dimpled
Groove
Canopy
Trim Ring
Figure 3