Advertisement
PRECAUTIONS AND GENERAL INSTRUCTIONS
Observe the following items without fail when disassembling and reassembling motorcycles.
● Be sure to replace packings, gaskets, circlips, O-rings and cotter pins with new ones.
CAUTION:
Never reuse a circlip after a circlip has been removed from a shaft, it should be discarded and a new circlip
must be installed.
When installing a new circlip, care must be taken not to expand the end gap larger than required to slip the
circlip over the shaft.
After installing a circlip, always insure that it is completely seated in its groove and securely fitted.
● Tighten bolts and nuts from the ones of larger diameter to those of smaller diameter, and from inside to out-side diago-
nally, with specified tightening torque.
● Use special tools where specified.
● Use specifide genuine parts and recommended oils.
● When more than 2 persons perform work in cooperation, pay attention to the safety of each other.
● After the reassembly, check parts for tightening condition and operation.
● Treat gasoline, which is extremely flammable and highly explosive, with greatest care. Never use gasoline as cleaning sol-
vent.
Warning, caution and note are included in this manual occasionally, describing the following contents.
WARNING
................ Personal safety of the rider is involved, and disregard of the information could
CAUTION
................. For the protection of the motorcycle, the instruction or rule must be strictly
NOTE
..................... Advice calculated to facilitate the repair of the motorcycle is given under
USE OF GENUINE HYOSUNG PARTS
To replace any part of the machine, use a genuine
HYOSUNG replacement part. Imitation parts or parts sup-
plied from any other source than HYOSUNG if used to
replace HYOSUNG parts, can reduce the machine' s per-
formance and, even worse, could induce costly mechani-
cal troubles.
result in injury.
adhered to.
this heading.
GENERAL INFORMA TION 1-8
Advertisement
