Vehicle Data; Entering Vehicle Data; Direct Data Entry; Copying Data From Orders - Bosch TTM 2104 Original Instructions Manual

9.

Vehicle data

9.1

Entering vehicle data

In the "Test protocol" view, data can be directly entered
or copied from existing orders.
No. Screen Description
element
1 Button Calling up orders via "Connected Repair".
"CoRe"
2 Button Calling up orders via "Entrance Check".
"Entrance
Check"
3 Orders List of available orders.
4 Vehicle data Enter registration number and additional
information or copy from orders. If ANPR is
available here, the registration number is
entered automatically.
5 Button Registration numbers and additional
"Delete" information regarding the currently
displayed measurement results are
deleted. Deleting the information must be
confirmed by entering the administrator
password.
6 Selecting The progress can be paged through by
the progress using both arrow buttons.
entry
7 Button "Save" Manually entered or called up data
regarding the currently displayed
measurements results are saved.
Robert Bosch GmbH
Vehicle data | TTM 2104 / TTM 2204 | 55 | en
9.1.1

Direct data entry

1. Select <Test protocol>.
2. Entry in the input box "Registration number / VIN" or
"Additional information".
3. Select the button <Save>.
9.1.2

Copying data from orders

Open orders can be called up via "Connected Repair" or
"Entrance Check".
1. Select <Test protocol>.
2. Select button in the "Connected Repair" or
"Entrance Check" section. Button is only active if
service is available via the network.
i
If a service is unavailable, a status message is
displayed:
Possible causes are a faulty configuration of the
"Tire Tread Connector" or a network problem.
"
The order list is displayed.
i
A message is displayed for both success or failure.
3. Select the desired order from the list.
 Selected vehicle data of that order are copied in
the input boxes.
4. Select the button "Save".
|
1 691 206 005 2019-02-25