Other Uses; Power Down; Locking Drawers - Seagate OneStor SP-3584 Installation & User Manual

OneStor® SP-3584 Installation & User Guide
Once a unit identification number is set, it is stored in the midplane VPD by the Enclosure Management
software and will appear when the enclosure is next powered on. In a situation where the VPD cannot
be read, or where there is no enclosure management (no SBB I/O modules, or a single module with
management failure) the enclosure will display "00".

4.4.2 Other Uses

The unit identification number can also be use for:
• Error codes.
• Unit location identifier – This function sets the display to flash (3 seconds on, 1 second off) until it
The unit identification number may be set via other methods - contact your storage vendor for details.
As above, the new setting will only be applied after a power cycle. All other functionality shall remain
the same as described above.

4.5 Power Down

For modules with RAID controllers, you must shutdown the application (contact your storage vendor
for details on how to do this) and then turn off the power.
For modules with EBOD controllers, switch off all installed PSUs by moving the power switches to the
"Off" position (see

4.6 Locking Drawers

A drawer can be locked shut by using a screwdriver with a Torx T20 bit to rotate both anti-tamper locks
until the red arrows point away from the center of the enclosure. See
Figure 4–3
32
is stopped, either through SES or by pressing the Input switch.
Figure 4–1 on page
Anti-tamper Locks
30).
Figure 4–3.