Timer Control - Dimplex Sierra 48 Owner's Manual

Operation
Heater Enable & Disable Function:
From the touchscreen controls touch and hold the Heat icon for 10 seconds. The
ember bed will flash 6 times to indicate that the heater function is disabled. When
the heat is disabled, pressing the Heat button will cause the ember bed to flash,
but the heater will not operate.
To enable the heater again, touch and hold the Heat icon for 10 seconds.
NOTE: This function cannot be set with the remote control.

TIMER CONTROL

Hold the timer icon for 5 seconds and the heat icon flashes. At this time, TuyaSmart
can connect the fireplace through Bluetooth. The Timer button is used to activate or
deactivate the sleep timer.
Pressing the Timer turns the timer on and '8h' appears on the display. Pressing
the Timer a second time within 10 seconds will turn the timer off. To set the time,
use the Level Selection control to select the desired time from the following:
8h-1h-2h-3h-4h-5h-6h-7h.
The fireplace will shut off after the selected time period. Switching the fireplace
OFF with the Power Button will clear any timer setting.
EMBER BED
The Ember Bed button changes the ember bed by cycling through the seven color
options: color rotation 'd1' and smoldering (fluctuating brightness) embers option
'd9'. With 'd8' through 'd2' displayed, the Level Selection button will adjust the
brightness of the ember bed from 3- High, 2-Medium, and 1-Low.
LEVEL SELECTION BUTTON
The Level Selection button is used to adjust the heat setting, as well flame and
ember bed brightness and timer setting. See relevant section for more details.
- 20 -
Operation
Remote control
Remove the battery cover on the back of the remote by sliding downwards and insert
2 x AAA batteries ensuring that the batteries are fitted correctly. Refit the battery cover.
For remote to function make sure the fireplace is plugged in and the ON / OFF Power
Switch on the fireplace is in the ON position. Each time the fireplace receives a remote
signal, the ember bed blink once. It does not blink when turned on and off.
Point the remote control directly towards the fireplace and press the appropriate
button to operate the fireplace. The remote has a memory function which will restart
the fireplace with the last settings except for the Sleep timer function which will always
reset to OFF.
Setting the current time of the remote control
Press and hold the button for 5 seconds to enter
the setting current time state. At this time,
will flash. You can press the or button to set the
current day of the week, 1 to 7 is optional. And press
the or button to set the current time of the hour,
0-23 is optional. And press the or
set the current time of the minute, 0-59 is optional. For
example, the current time is 8:42 pm on Friday and the
remote control displays as follows show (fig.2).
No action for 5 seconds or press button to confirm
the current time.
,
button to
- 21 - www.dimplex-fires.eu
EN