Operation - Dimplex Sierra 48 Owner's Manual

Operation

This fireplace can be operated by both a remote control and touchscreen
controls. Once the fireplace has been properly connected to an earthed electrical
socket-outlet ensure the manual On/Off switch, located on the right hand side of
the fireplace, is in the 'ON' position.
Once the fireplace is turned on the digital display and the control icons on the
front glass will illuminate. If no button or icon is pressed within 10 seconds, the
fireplace controls will deactivate by the digital display turning off first and then the
icons. To reactivate the controls press any button on the remote or touch any icon
on the front glass.
7 6 5 4 3 2
1. Power ON/OFF
2. Flame Control
3. Heat ON/OFF
4. Timer
5. Ember Bed
6. Level Selection
7. Digital Display
NOTE: The heater on your fireplace may emit a slight, harmless odour when first
used. This odour is a normal condition caused by initial heating of internal heater
parts and will not occur again.
CUTOFF SWITCH
NOTE: There is a safety temperature cutoff switch (cutout) inside the heater. If the
heater overheats, the cutout will shut off the supply power.
It can be reset by unplugging the unit and waiting 5 minutes before plugging
the unit back on.
CAUTION: If you need to continuously reset the heater, unplug the unit and call
technical service T. +31(0)513 656500 or e-mail: info@dimplex-fires.eu.
1
- 18 -
Operation
POWER ON/OFF
The ON/OFF button turns the fireplace ON and OFF. When the fireplace is OFF,
pressing the ON/OFF button on the remote control or touching the icon on the
front glass will turn on the fireplace. If the ON/OFF button is pressed again within
10 seconds it will turn OFF the fireplace. With inactive controls, press twice to turn
OFF the fireplace. The first press on the ON/OFF button lights up the touchscreen
icons and activates the controls.
The fireplace has a built-in memory function. When the fireplace is turned back
on, the display will show the last selected function and it will start at the last
used settings (except timer). If the fireplace is disconnected from the main power
source, it will restart at the default settings.
FLAME CONTROL
This button is used to turn flames ON, to alter the flame color and to turn flames
OFF. Press the Flame button multiple times to cycle through 7 solid color options
(L8, L7, L6, L5, L4, L3, L2), color rotation option (L1) and flames OFF.
While L8, L7...or L2 is displayed, press the Level Selection button to change the
brightness of the flames from the available options: 3- High, 2-Medium and 1-Low.
Hold the flame icon for 5 seconds to turn the sound of flame burning ON or OFF.
HEAT ON/OFF
Pressing the Heat control turns the heater on and off.
With Heat ON and set temperature displayed, press the Level Selection button
multiple times to cycle through the 11 temperature settings:
27°C, ON, 18°C, 19°C, 20°C, 21°C, 22°C, 23°C, 24°C, 25°C, 26°C .
'ON' means the heater operates continuously.
- 19 - www.dimplex-fires.eu
EN