Advertisement
SAFETY INSTRUCTIONS
GENERAL WARNINGS
The fork is an important element that has a direct influence
on the stability of the bike.
This manual must be consulted before using your shock
absorber and for the dura�on of its life.
CAUTION opera�ons may impair your safety or cause damage to your suspension. Be sure to take note of these
warnings.
IMPORTANT INFORMATIONS
These indica�ons are intended to allow you to op�mize the opera�ons described in this manual or op�mize the
performance of your suspension.
TOOLS
To carry out adjustments and rou�ne maintenance of your fork, you will need the following tools :
TOOL
Metal saw
Steer tube cut-out
Wheel axle/ crown fork
1.5/5mm Allen key
26mm Socket
21mm Socket
Compression bloc nut
14/16mm Flat wrench
Hydraulic stop position
If necessary, or for any service opera�on, please contact an
authorized BOS suspension.
A�er installa�on, test your bike at a slow pace to make sure
that everything works properly.
USE
FIGURE
screw
Top cap
ASSEMBLY
The assembly of the Idylle fork on your frame requires
par�cular a�en�on in order to guarantee op�mal safety
condi�ons. Please make sure you follow the instruc�ons
below.
1.1
Pivot
Before cu�ng the pivot of your fork, measure the necessary
length of pivot, taking into account the total height of your
headset, stem, and adding a margin of 5 to 10mm.
Never disengage the pivot tube from the lower clamp, even if the pivot tube is too short, or when changing the
frame. It is impera�ve to change the set for important security reasons.
1.2
Front wheel moun�ng
To assemble the front wheel, proceed as follows :
1.
Loosen the fork axle screws (1).
2.
Unscrew the axle (2) to remove it.
3.
Place the front wheel.
4.
Insert the axle and screw it in un�l it stops.
5.
Tighten the axle locking screw (torque 4N.m).
The disassembly of the front wheel must respect the
reverse previous opera�ons.
1.3 Moun�ng the brake caliper
The Idylle brake caliper bolt pa�ern uses a post mount 200
(PS200) standard mount. In order to mount the disc brake
device, apply the following recommenda�ons :
1.
When fi�ng the brake caliper, follow the
manufacturer's instruc�ons for the brake model used.
2.
Ensure that all fixing screws are �ghtened to the
torque recommended by the manufacturer. For that, refer
to the user manual provided by the manufacturer. It is
recommended to install a new set of pads to ensure be�er
alignment.
3.
Pass the brake hose from the caliper through the
inside of the cas�ng, then through the hose guide provided
4.
Finish by tes�ng the braking system on flat ground
before riding on the trails.
4
Calculate the length as below:
Length of the head tube of the frame + height of the headset
+ height of the stem + 5 to 10mm.
•
The disc brake caliper moun�ng bolts must
have 10 mm of thread engagement with the
fork.
•
The disc brake caliper moun�ng bolt
�ghtening torque level must be 10 n.m.
5
Advertisement
