Inserting The Flow Sensor - GERATHERM Spirostik Complete Instructions For Use Manual

7.3

Inserting the Flow Sensor

1
2b
2
Page 54
1. Insert Spiraflow [2] into the handle
2a
2
1
2. Snap the Spiraflow [2] into the
1
3. Spiraflow not only must be fixed, but
Serial no.: xx|8|102|yyy and 2103xxxxx
[1].
For this:
Align the Spiraflow so that the
interrupted guide rib [2a] and the nose
on the handle are on the same side
and
the pressure tapping holes [2b] show
in the direction of the handle.
handle [1]!
For this:
Apply light pressure.
also locked in place!
For this:
Check the correct position in the
handle on the basis of the Interrupted
guide rib and the nose and correct it if
necessary.
Version: 7 | Release date: 14. July 2021
Instructions for Use
Spirostik Complete