Table of Contents
Advertisement
Periodic maintenance and adjustment
1. "H" level mark
2. "L" level mark
6.
If the engine oil is below the "L" level
mark, add sufficient oil of the recom-
mended type to raise it to the "H" level
mark. (See page 81 for the recommend-
ed oil.) NOTICE: When adding the en-
gine oil, be careful not to fill above the
"H" level mark on the dipstick. Use
only the recommended oil. (See page
81.) Make sure that no foreign material
enters the engine oil tank.
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Close the shroud.
To change the engine oil (with or without oil
filter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Open the shroud.
4.
Remove the right side cover and the bot-
tom panel.
52
1
1. Right side cover
2. Screw
3. Bolt
[ECS00463]
1. Bolt
2. Bottom panel
5.
6.
1. Oil level gauge coupler
2. Oil filler cap
2
3
Place an oil pan under the oil tank to col-
lect the used oil.
Disconnect the oil level gauge coupler.
2
1
2
Advertisement
Table of Contents
