Troubleshooting - Chicco Essential Digital Audio Instructions For Use Manual

TROUBLESHOOTING

If you experience problems, please first check the following list and check that:
• Both units are on
• Both units are properly connected to the power socket via the mains adapter (1), or that batteries are
charged.
FAULT
The parent
unit (receiver)/
child unit
(transmitter)
EC
power
uent
and link
indicator
light (5)
is off
ons
The parent unit
(receiver) does
not emit any
sounds.
Interference
CAUSE
- Child unit (transmitter) and/or
parent unit (receiver) off.
- Child unit Alkaline batteries
(not included) and/or parent unit
lithium-ion battery completely
discharged.
- Mains adapter disconnected or
not connected correctly.
- No mains voltage.
- No discernible sounds are arriving
to the child unit (transmitter)
- The voice activation function has
been selected
- Parent unit (receiver) volume set
at minimum
- Child unit Alkaline batteries and/
or parent unit lithium-ion battery
completely
discharged
- The parent unit (receiver) may
be off
In rare cases, even if FHSS
technology ensures high immunity
to interference
from analogue devices,
interference can be caused by
the presence of another intercom
or similar transmission device
switched on nearby.
Electromagnetic pollution
(proximity to antennas with radio
transmitters, high
voltage cables, etc.).
SOLUTION
- Switch on the child unit (transmitter)
and/or the parent unit (receiver)
- Replace Alkaline batteries
in the child unit and/or charge
rechargeable lithium-ion battery in the
parent unit
- If the units are powered via mains
adapter, verify that this device is
correctly connected to a mains outlet
- Check that the outlet is being
powered.
- Just as soon as discernible sounds
from the environment are present,
the transmitter will be activated.
In any case, for peace of mind, test
transmission with the help of another
person who can try to speak in the
room the child unit (transmitter) is on.
- Check the position of the voice
activation or continuous transmission
ON/OFF selector.
If the selector is set to ON, the voice
activation function is active.
As soon as sounds present in the child
unit environment exceed the threshold
for voice activation, the parent unit will
emit sounds.
- Adjust parent unit (receiver) volume
until sounds are audible, pressing
the + volume adjustment button (3a).
- Replace Alkaline batteries
in the child unit and/or charge lithium-
ion battery in the parent unit
- Switch on the parent unit (receiver)
Move away from analogue equipment
and/or leave
the area in which it is located.
25