Io-Con-2 Module; Overview; Features; Device Family Support - Equinox Systems PPM3 Reference Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EQ-IOCON-3 - MOD PPM3 CONN-3 I/O ATMEGA JTAG
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

7.0 IO-CON-2 Module

7.1 Overview

This IO-CON module is designed for use with any Atmel microcontroller which can be programmed
via the 3-wire SPI port + RESET. Supported devices include the Atmel 89S, AT90S, ATmega and
ATtiny devices families. The module features the Equinox and Atmel 10-way ISP headers plus a
'Wire-wrap' connector suitable for wire-wrapping connections from a Test Fixture. Please refer to
Section 3 for a detailed description and pin-out of the 6-way and 10-way ISP headers.

7.2 Features

•
Plugs into suitable Equinox programmer eg. PPM3 Module
•
Atmel 10-way IDC ISP Header
•
Atmel 6-way IDC ISP Header
•
Equinox 10-way IDC ISP header
•
Single-in-line header with all programmer I/O brought out for wire-wrapping to bed-of-nails
probe wires
•
Screw terminals for power connections
•
Target Vcc Status LED
•
Link to connect / isolate the programmer Vcc from the Target Vcc

7.3 Device Family Support

This I/O Connection Module supports ISP programming of the following device families:
Low / High Voltage SPI programming algorithm:
•
Atmel AT89S (LV SPI)
•
Atmel AT90S (LV SPI)
•
Atmel ATtiny (LV SPI)
•
Atmel ATtiny (High Voltage)
•
Atmel ATmega (LV SPI)
•
Atmel 90CAN (LV SPI)
•
Atmel 90USB (LV SPI)
•
Atmel 90PWM (LV SPI)
•
Atmel ATmega PICO (LV SPI)
•
Zensys ZW (LV SPI)
I2C Serial EEPROM programming algorithm:
•
Atmel AT24C
•
Atmel AT24HC
•
Atmel AT34C
UART – Boot Loader' algorithm:
•
Atmel T89C51Rx2 (UART – Boot Loader)
•
Philips P89C51Rx2 (UART – Boot Loader)
•
Philips P89C66x (UART – Boot Loader)