Equinox Systems PPM3 Reference Manual page 11

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EQ-IOCON-3 - MOD PPM3 CONN-3 I/O ATMEGA JTAG
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
EQ-IOCON-3 I/O Connector Module 3 (JTAG) – Fast Connect Version
I/O connector module for In-System Programming (ISP) of Atmel microcontrollers
using JTAG protocol
Features:
•
•
•
•
•
•
•
•
Please note
The 'Atmel AVR JTAG License' (Order code: PPM3A1-UPG7) is also required to
enable the PPM3 to program Atmel AVR devices via JTAG.
EQ-CALCON EQ-CALCON Module
The EQ-CALCON Module is a special plug-in I/O Connector Module for the PPM3-
MK2 programmer which is used to facilitate very accurate calibration of the Internal
Oscillator of an Atmel ATmega or ATtiny AVR microcontroller. The module features
an on-board high accuracy 32kHz Oscillator Module which can be connected to the
target AVR microcontroller MOSI pin during the Oscillator Calibration Procedure as
described in the Atmel Application Note 'AVR053: Calibration of the Internal
Oscillator'.
Features:
•
•
•
•
•
•
•
Please note
The use of this module requires development of / purchase of suitable 'Calibration
Firmware' for the chosen ATmega AVR microcontroller.
Plugs into suitable Equinox programmer e.g. PPM3 Module
Atmel 10-way JTAG IDC ISP connector (same as JTAG-ICE)
Atmel 6-way IDC ISP Header
Equinox 10-way IDC ISP header
Single-in-line header with all programmer I/O brought out for wire-wrapping
to bed-of-nails probe wires
Screw terminals for power connections
Target Vcc Status LED
Link to connect / isolate the programmer Vcc from the Target Vcc
Plugs into suitable Equinox programmer e.g. PPM3 Module
Atmel 10-way JTAG IDC ISP connector (same as JTAG-ICE)
Atmel 6-way IDC ISP Header
Equinox 10-way IDC ISP header
Screw terminals for power connections
Target Vcc Status LED
Link to connect / isolate the programmer Vcc from the Target Vcc