Connector Layout Schematic - Equinox Systems PPM3 Reference Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EQ-IOCON-3 - MOD PPM3 CONN-3 I/O ATMEGA JTAG
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

9.4 Connector Layout Schematic

The relative positions and orientation of the various connectors on this module are shown in fig. 9.4.1.
below. Please refer to fig. 9.4.2 for an explanation of each item.
Figure 9.4.1
Item ref Part no Part Description
1 LED1 RED LED
2 J5 PCB interconnect
3 J29 Power supply input
4 J21 Target Fast connector 1
5 J22 Target Fast connector 2
6 TP2 Scope Test Point
7 J12 PCB interconnect
8 J28 Vcc Select
9 J30 6-way Header
10 J20 10-way Header
11 J19 10-way Header
Figure 9.4-2
Functional Description
Power is applied to PPM3
PCB inter-connectors (on underside of board)
DC Power input connector – screw terminal
Clip in Fast-connect connector (6-way)
Clip in Fast-connect connector (6-way)
Scope ground test point
PCB inter-connectors (on underside of board)
Jumper to allow connection of PPM3 Vcc to target
Vcc
Atmel 6-way IDC 0.1" ISP Header
Atmel 10-way IDC 0.1" JTAG Header
Equinox 10-way IDC 0.1" ISP Header