Thiele Streamfeeder Pro Series Manual page 88

Pro Series System
Menus (continued)
81
MENU 1: SPEED
Allows you to set the desired speed value from 1 to 100 percent (This
is the maximum speed when Speed Following = Off; See Menu 14:
CONVR).
To change the speed value (If Speed Following = Off):
1. Press the Enter key to engage cursor.
2. Use the Up/Down arrow key or Numeric keypad to reach your
desired speed percentage.
2a. Press the Enter key to save new speed percentage.
2b. Press the MENU key to restore old speed percentage and return
to "suspended" screen.
MENU 2: SIZE
Allows you to change the batch size value (If Speed Following = Off)
To change the batch size value (If Speed Following = Off):
1. Press the Enter key to engage cursor.
2. Use the Up/Down arrow key or Numeric keypad to reach your
desired batch size.
3. Press the Enter key to save new batch size. OR Press the MENU
key to restore old size and return to "Run Display"
MENU 3: CLEAR
Allows you to reset the accumulated number of Cycles completed to
zero. Press the Enter key to clear the number.
MENU 4: SKIPS
Allows you to set the number of fl ights to skip between feeds from 0
to 99.
MENU 5: DELAY
Sets the amount of time that the flight sensor (0.0 to 9.9 seconds) and/
or sheet sensor (.00 to .99 seconds) will delay after a flight (or sheet
edge) is detected before feeding or before stopping respectively. If
Speed Following = On, this will have a direct effect on the dispensing
of the product in relation to the feeder trigger point and the encoder
position reading.
To enter the delay value:
1. Use the Up/Down arrow keys to position cursor arrow by the sensor
(flight or sheet) you wish to delay.
2. Press the Enter key to engage cursor.
P S Si-1750 M
ro erieS anual