Thiele Streamfeeder Pro Series Manual page 32

Stopping the Feeder
Clearing a Jam
Pressing the JOG key to advance the feed belts
may clear some jams. If the JOG key does not
work, use the procedure listed.
Shutdown
25
The feeder can be stopped either manually or automatically. Pressing
the STOP key will stop feed cycles and return the feeder to the
"Suspended" status.
When a product fails to be staged in a preset amount of time, the
feeder will automatically timeout or stop. If this occurs, the display
will read "Feeder Timeout." Determine and resolve the cause of the
timeout and press the CYCLE
If a jam occurs during operation, follow these steps:
1. Turn power
2. Open the discharge safety shield.
3. Remove jammed product from feeder. While doing so, try to
determine the cause of the jam.
4. Verify whether any adjustments are loose. If so, refer back
to Section 2, Preparing for Operation, for proper adjustment
procedures.
Should you not be using a the feeder for long periods of time, follow
these steps to ensure a safe and secure storage:
1. Turn power
2. Disconnect feeder from AC power source.
3. If removing the Flight-Detect photo sensor from the produc-
tion line, disconnect cable connector from feeder and coil up
for storage.
key to resume feeding.
Off.
Off.
P S Si-1750 M
ro erieS anual