Thiele Streamfeeder Pro Series Manual page 18

Avoid adjusting the side guides too close to the
feed belts. Even slight contact with the belts can
cause premature wear or even belt failure.
Vertical Adjustment of Side Guides
11
To adjust each side guide for proper horizontal spacing, follow these
steps:
1. With a small stack of material in the hopper, start by loosening
the bottom adjustment knob (counter-clockwise).
2. Grasp the lower part of each guide and move to the recom-
mended distance from the product: 1/16 in. (1.6 mm) for each
edge, 1/8 in. (3.1 mm) overall. Tighten the lower adjustment
knob after you do this for each guide.
4. At the upper part of each guide, loosen the top adjustment
knob (counter-clockwise).
5. Grasp the upper part of each guide and move to the recom-
mended distance from the product: 1/16 in. (1.6 mm) for each
edge, 1/8 in. (3.1 mm) overall. Tighten the upper adjustment
knob after you do this for each guide.
6. Visually check both guides for parallel.
Horizontal Adjustment of Side Guides
P S Si-1750 M
ro erieS anual