Troubleshooting - Thiele Streamfeeder Pro Series Manual

4

Troubleshooting

This table will provide you with quick solutions to the more common day-to-day problems you may encounter.
Quick-Look Troubleshooting
Problem
No AC power to
feeder
Feeding doubles
Continuous feeding,
no gap
Continuous feeding,
with gap
P S Si-1750 M
ro erieS anual
Cause
1. On/Off switch in "Off" (or "0" position).
2. Power cord loose or not plugged into
outlet (or AC power source).
3. Female end of power cable loose or not
plugged into AC power inlet at rear of
feeder.
4. Interconnect cable loose or not
connected at controller box.
1. Gate assembly improperly adjusted
(possibly more than one sheet
thickness).
2. Back wedge improperly adjusted.
3. Worn angled edge (or if applicable,
O-rings).
4. Product interlocking.
5. S a t c i t b u d l i u . p
1. Possible overlapping.
2. Incorrect hold-down pressure
adjustment.
1. Photo sensor out of adjustment relative
to product (target). Background objects
such as shafts, guides, belts, and
supports may be causing false returns.
Solution
Check that switch pressed to "On"
(or "—" position).
Check and secure power cord at AC outlet.
Check and secure cord at AC power inlet
(rear of feeder).
Check and secure interconnect cable end
at controller box. Make sure it is locked.
Review gate assembly adjustment in
Section 2, "Preparation for Operation".
Review back wedge adjustment in
Section 2, "Preparation for Operation".
Replace angled edge. Or if applicable,
rotate O-rings. (see Section 5, "Inspection
and Care", for procedure). If wear is
excessive, consult with a qualified
technician.*
Check product and source.
C h e k c p o r d u t c a n d o s u c r
See "Feeding Doubles" above.
Review hold-down setting in Section 2,
"Preparation for Operation".
Re-adjust feeder extension/photo sensor to
"see" product only. Review photo sensor
adjustment in Section 2, "Preparing for
Operation".
. e
26