7: Selecting The Speaker System - Sony STR-DH700 Operating Instructions Manual

Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAU021 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 96).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
30
US
7: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
SPEAKERS
?/1
TONE INPUT SELECTOR
SPEAKERS
TONE MODE INPUT MODE TUNING MODE TUNING
PHONES
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
To select
The front speakers connected to the
SPEAKERS FRONT A terminals
The front speakers connected to the
SPEAKERS SURROUND BACK/
BI-AMP/FRONT B terminals
The front speakers connected to both
the SPEAKERS FRONT A terminals
and SPEAKERS SURROUND
BACK/BI-AMP/FRONT B terminals
(parallel connection)
* To select "SP B", set "SB ASGN" to "SPK B" in
the System settings menu (page 43).
To turn off the speaker output, press
SPEAKERS repeatedly until the "SP A" and
"SP B" indicators on the display light off.
Note
You cannot switch the front speaker system by
pressing SPEAKERS when the headphones are
connected to the receiver.
MASTER VOLUME
MEMORY/ 2CH/
ENTER A.DIRECT A.F.D. MOVIE MUSIC DISPLAY DIMMER MUTING
VIDEO 2 IN
AUTO CAL MIC VIDEO L AUDIO R
Light up
SP A
SP B*
SP A and
SP B*