7: Selecting The Speaker System - Sony STR-DG820 Operating Instructions Manual
Multi channel av receiver
Hide thumbs
Also See for STR-DG820:
- Operating instructions manual (108 pages) ,
- Service manual (96 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAP021 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 90).
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.
US
7: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
SPEAKERS (OFF/A/B/A+B)
ON/STANDBY
POWER
MASTER VOLUME
TONE MODE
TUNING MODE
DISPLAY
INPUT MODE
TONE
TUNING
INPUT SELECTOR
SPEAKERS
(OFF/A/B/A+B)
MEMORY/
2CH/
ENTER
DIMMER
A.DIRECT
A.F.D.
MOVIE
MUSIC
VIDEO 2 IN/PORTABLE AV IN
PHONES
VIDEO
L AUDIO R
AUTO CAL MIC
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
To select
Light up
The speakers connected to the
SP A
SPEAKERS FRONT A terminals
The speakers connected to the
SP B
SPEAKERS FRONT B terminals
The speakers connected to both the
SP A + B
SPEAKERS FRONT A and B
terminals (parallel connection)
To turn off the speaker output
Press SPEAKERS (OFF/A/B/A+B)
repeatedly until the “SP A”, “SP B” and
“SP A+B” indicators on the display do not
light up.
“ALL OFF” appears on the display for a while.
Note
You cannot switch the front speaker system by
pressing SPEAKERS (OFF/A/B/A+B) when the
headphones are connected.
Page 30
Hide quick links:
Advertisement
Table of Contents
