Install And Remove Transceiver Modules; Install And Remove Sfp Modules - Cisco NCS 5500 Series Manual

Install and Remove Transceiver Modules

5. Grasp the MPA and pull the MPA from the chassis. (You have already disconnected the cables from the
MPA.)
Install and Remove Transceiver Modules

Install and Remove SFP Modules

Before you remove or install an SFP or SFP+ module, read the installation information in this section.
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Caution
Protect the line card by inserting a clean SFP/SFP+ module cage cover, shown in the figure below, into the
optical module cage when there is no SFP or SFP+ module installed.
Figure 6: SFP/SFP+ Module Cage Cover
Caution
Protect the SFP or SFP+ modules by inserting clean dust covers into them after the cables are removed. Be
sure to clean the optic surfaces of the fiber cables before you plug them back into the optical ports of another
module. Avoid getting dust and other contaminants into the optical ports of your SFP or SFP+ modules,
because the optics do not work correctly when obstructed by dust.
Connect Router to the Network
10
Connect Router to the Network