Recording - Philips FW-C55 Manual

All manuals and user guides at all-guides.com
MINI HIFI SYSTEM
PROGRAM SHUFFLE
REPEAT TIMER REC
NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz 1KHz
CLOCK/
TIMER CD1 • 2 • 3 BAND
CD TUNER
PROG
SEARCH • TUNING STOP•CLEAR PLAY PAUSE
SOUND NAVIGATION
INCREDIBLE
SURROUND
DIGITAL
SOUND CONTROL
OPEN
TAPE 1
pg 01-26/C55/22-Eng new 21
Notes:
– It is not possible to change tape side
during recording.
STEREO
BACK
FRONT HSD
– If you do not intend to record via the
2KHz 4KHz 8KHz
microphone, unplug the microphone to
RDS
avoid accidental mixing with other
NEWS/TA
TAPE 1 • 2 CDR/VIDEO
recording source.
TAPE AUX
– For recording, use only tape of IEC type I
A. REV
PRESET
PREV SIDE NEXT
(normal tape) or IEC type II (Cr0 2 ).
– The tape is secured at both ends with
MIC
LEVEL leader tape. At the beginning and end of
DYNAMIC BASS
MIC
tape, nothing will be recorded for six to
BOOST
seven seconds.
– The recording level is set automatically,
regardless of the position of Volume,
DBB, Incredible Surround or DSC.
OPEN
– To prevent accidental recording, break
out the tab on the left shoulder of the
TAPE 2
tape side you want to protect.
– If " CHECK TAPE " is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr0 2 tape
detection hole when covering the tab
opening.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.

RECORDING

Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press í or ë to select the recording
tape side (see Tape Side under TAPE
section) .
4 Press CD, TUNER or AUX.
• Start playback of the selected source.
5 Press REC to start recording.
™ The starts flashing.
REC
6 Press Ç to stop recording.
Notes:
– Only å å å å å or ∂ ∂ ∂ ∂ ∂ mode is available
during recording .
– During recording, it is not possible to
listen to another source.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 with full spool to the left and a
blank tape into tape deck 2 with full
spool aside.
3 Press í or ë to select the recording
tape side (see Tape Side under TAPE
section) .
3/6/00, 11:43 AM
21
3139 116 19551