One Touch Recording - Philips FW 316C Instructions For Use Manual

RECORDING
=A '
eit
B STZL COULD COMITOL
Lol
rFantaro' oe
!
{
1
|
| rst
| Os
|
\
STARA
Notes:
~ For recording, use only tape of IEC type | {normal tape).
— The tape is secured at both ends with leader tape. At
the beginning and end of tape, nothing will be
recorded for six to seven seconds.
— The recording level is set automatically, regardless of
the position of VOLUME, DBB or Incredible Surround {if
available) .
— Jo prevent accidental recording, break out the tab on
the left shoulder of the tape side you want to protect.
MINE HIFI SYSTEM
TAPE 1+ TAPE 2
CUP OULO CONTE ON
hy i/ AN
: eS (cm) p peas) (c=) Ga)
' }
oe
aes
SIS
rt 4
One Touch Recording
1
2
3
4
For One Touch Recording, as saon as you press
RECORD, the current source will be recorded on tape
deck 1.
Load a blank tape in tape deck 1.
Press RECORD on tape deck 1 to start recording.
— The REC flag starts flashing.
Press PAUSE to interrupt recording.
Press STOP OPEN on tape deck 1 to stop recording.
Dubbing tapes (from tape deck 2 to tape deck 1)
1 Load the prerecorded tape into tape deck 2 anda
blank tape into tape deck 1.
— Make sure that both tapes have their full spoot to
the left.
2 Press DUBBING to switch between normal and high
speed dubbing.
— "NERMAL ® (normal speed) or 'fF AST* (high speed)
will be displayed.
— HSD flag appears on the display for high speed
dubbing.
3 Press PAUSE on tape deck 1.
4 Press RECORD on tape deck 1.
5 Press PLAY on tape deck 2.
— Recording will start automatically.
— The REC flag starts flashing.
6 Press STOPeOPEN on tape deck 1 and tape deck 2 to
stop dubbing.
Notes:
— At the end of side A, flip the tapes to side B and
repeat the procedure.
— Dubbing of tapes is only possible from tape deck 2 to
tape deck 1.
— To ensure good dubbing, use tapes of the same length.
— During high speed dubbing in Tape mode, the sound is
reduced to 2 low volume.