Management - Draytek Vigor 2700 User Manual

Automatically Update Interval
Click OK to save these settings.
3 . 1 2 . 6 M a n a g
3 . 1 2 . 6 M a n a g
This page allows you to manage the settings for access control, access list, port setup, and
SMP setup. For example, as to management access control, the port number is used to
send/receive SIP message for building a session. The default value is 5060 and this must
match with the peer Registrar when making VoIP calls.
Enable remote
firmware upgrade
Allow management
from the Internet
Disable PING from
the Internet
Access List
Default Ports
User Defined Ports
Enable SNMP Agent Check it to enable this function.
Get Community
Vigor2700 Series User's Guide
e m e n t
e m e n t
Chick the checkbox to allow remote firmware upgrade through FTP
(File Transfer Protocol).
Enable the checkbox to allow system administrators to login from the
Internet. By default, it is not allowed.
Check the checkbox to reject all PING packets from the Internet. For
security issue, this function is enabled by default.
You could specify that the system administrator can only login from
a specific host or network defined in the list. A maximum of three
IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the router.
Subnet Mask - Represent a subnet mask allowed to login to the
router.
Check to use standard port numbers for the Telnet and HTTP servers.
Check to specify user-defined port numbers for the Telnet and HTTP
servers.
Set the name for getting community by typing a proper character. The
default setting is public.
Select a time interval for updating from the NTP server.
139