Table of Contents
Advertisement
SECTION 4—SEAT/BACK
Installing/Removing Seat Posture Belt
NOTE: For this procedure, refer to FIGURE 4.3.
1. Remove seat cushion from wheelchair, if necessary.
2. Remove the mounting screw and locknut that secures the seat posture belt half to the
back cane.
3. Repeat STEP 2 for opposite side, if necessary.
4. Engage the two halves of the new seat posture belt.
5. Align the mounting holes on the rear pivot socket hole on the wheelchair frame
and one end of the new seat posture belt.
6. Secure the new seat posture belt with one mounting screw and washer. Tighten
securely.
7. Repeat STEPS 5 and 6 for the opposite side of the seat posture belt.
8. Reinstall seat cushion onto wheelchair, if necessary.
NOTE: Seat upholstery removed for clarity on figure 4.3.
Backrest
cane
Seat Posture
belt Half
Mounting
screw
FIGURE 4.3 Installing/Removing Seat Posture Belt
1 4
Seat Posture
belt Half
Mounting
screw
Advertisement
Table of Contents
