Description Of Fdap Parameters - Honeywell OW-FDAP31 Manual

4 FDAP CONFIGURATION
4.3

Description of FDAP parameters

Once the FDAP joins the network, you can configure and monitor the FDAP by using OneWireless user
interface. The Selection Panel in the OneWireless user interface provides a list of all the devices in the
OneWireless Network. The Property Panel in the OneWireless user interface provides configuration properties
of all the devices configured in the OneWireless Network. Select the required FDAP from the list of devices in
the Selection Panel, and then view the FDAP parameter details in the Property Panel.
The following table describes the FDAP parameter details.
Panel
Access Point Summary
34 www.honeywell.com
Figure 10: FDAP Property Panel
Table 4: FDAP parameters in the selection panel
Group elements
Identification
Description
Tag Name: Displays the default device name.
You can rename the device. Device name can
be up to 16 alphanumeric characters long and
it should begin with an alphabet.
Status: Displays the device status as Joined
or Offline.
Default Map: You can select the required
map on which the device must be placed.
Description: Displays the entered description
for the device. You can type the required
description for the device.
Displays the identification details like
Vendor, Model (device type), Serial Number
(EU ID of the device), Radio Revision
(firmware revision number), Template Type,
and Template Revision.