Mount The Fdap Gen3; Pole Mounting - Honeywell OW-FDAP31 Manual

3 FDAP INSTALLATION
3.9

Mount the FDAP Gen3

The assembled FDAP Gen3, along with antennas and lightning suppressors (if required) can be mounted in its
site location. The FDAP Gen3 enclosure can be mounted on a 2-inch pole or on a wall using the appropriate
optional mounting kit that is available with the unit.

3.9.1 Pole mounting

When pole mounting the FDAP Gen3, you can assemble and install the mounting hardware at the site. The
mounting kit includes the following items:
(1) Mounting plate
(2) U-bolts with nuts
(3) Screws (to attach the FDAP Gen3 to the mounting plate)
(4) Washers (Split lock washer, Flat lock washer, Lock washer)
The pole mounting kit comprises of mounting plate, U-bolts with nuts, screws and washers as displayed in
"Figure 5: Pole mounting". When using the mounting plate for the pole installation, secure the FDAP Gen3 to
the bracket using the screws supplied with the bracket kit. The FDAP Gen3 can be mounted to the left or to
the right of the pole using the same mounting hardware. It can also be mounted in line with the pole.
However, if the integral antennas are too close to the pole, it might cause RF communication problem. For
inline mounting, the FDAP Gen3 integral antennas should be on the top of the mounting pole.
26 www.honeywell.com
Figure 5: Pole mounting